I added a design to a blank tote bag using light-sensitive Inkodye and a stencil cut from freezer paper.
Inkodye is a water-based dye that works on natural materials like fabric and wood, and develops its color in the sun. It dyes fabrics permanently, and I like it better than fabric paint since it soaks into the fabric and keeps it soft and flexible, unlike fabric paints that can be stiff and sit on the surface of a textile. Plus, it's really fun watching the color develop!
To make a similar tote, you can create your own design or download the Big Fun stencil I made.
Print the design and trace it onto the dull side of plastic-coated freezer paper, available at grocery stores. Or, save yourself a step and print directly on freezer paper cut to fit through your printer. Tape a piece of freezer paper, shiny side down, to a sheet of copy paper and print on it. It will come out a bit curly and lightly fused to the carrier sheet if you use a laser printer like I did, but it should peel off easily.
Cut out the letters and shapes. Remember that any empty hole will get filled with color, and no dye will go where the pieces of paper sit.
With an iron set to the appropriate temperature for your fabric (likely the cotton setting), iron the paper pieces to the tote, shiny side down. The iron will very slightly melt the plastic coating, sticking the paper to the canvas. Give the pieces an initial quick, light press to make sure they're where you want them. If not, peel them up and reposition. Then press down firmly with the iron and make sure all the edges are sealed so no dye will seep under them. Once they're stuck down, the pieces are really stuck, and will probably tear if you try to peel them off.
If there are any areas you're worried about getting dye— you know, if you tend to lose your mind a little and start painting outside the lines— mask those off with painter's tape. Place a piece of freezer paper inside the tote to prevent any dye from soaking through to the back side.
Then, in a dimly lit room, brush on Inkodye with a foam brush. Or any kind of brush or roller will do the job! Try for even coverage. The fabric doesn't have to be completely saturated; you just need a nice even coat on the surface of the textile.
(You can mix Inkodye with water to make it go further, if you like. A 1:1 ratio of dye to water will still yield maximum vibrance. Add more water to make pastels, or mix colors as you would paint.)
Blot off any excess dye with a paper towel.
Place the tote in the sun. The color will start to develop instantly! Here's the tote after 30 seconds, a minute or two, and fully exposed after 10 minutes.
Peel off the paper, my favorite part.
If you like, you can wash the tote with laundry detergent to remove any excess dye. Or just let it air dry and call it a day.
0 comments:
Post a Comment